bakit empty battery ang olympus u 1000 digicam kahit bagong charge ang battery?

[yob_floria]

nai charge ko po yung battery at test ko pa sa multimeter nasa 3.8v to 3.9v pero pag open ko sa cam eh empty battery ang prompt nya,.... pag 3.9v po ba ang measure ko sa lithium battery ay ok po ba yun?..mga ilang volts ba ang full charge nang lithium battery?...o sira na talaga cam ko?.....pls help me guys...TIA....

[rdpzycho]

ilang years na 'yung battery? depende sa actual design nung battery, can range from 3.8V to 4.2V ang full charge. karamihan ng Li family battery merong IC sa loob at madalas may communication dito 'yung connected device. pwedeng para sa design nung firmware, low battery na talaga 'yung binibigay nung IC sa battery.

[yob_floria]

n

ilang years na 'yung battery? depende sa actual design nung battery, can range from 3.8V to 4.2V ang full charge. karamihan ng Li family battery merong IC sa loob at madalas may communication dito 'yung connected device. pwedeng para sa design nung firmware, low battery na talaga 'yung binibigay nung IC sa battery.

nasa 3 years na po ang battery...na itry ko yung bagong battery sa mall eh empty battery pa rin di ko lang alam kung tama ba yung initial charge nya, eh di ko na lang binili baka kasi sa cam yung sira sayang din....

[rdpzycho]

kung bago 'yung battery, malaki 'yung probability na wala siyang charge. pwede mo ring subukang dalhin sa service center or sa shop na binilihan para ma-test kung may battery silang may charge.

[kalansing]

may sony digicam ako ganyan din ang problema. yun pala problematic talaga ung battery-camera model combination nito. searched sa net at ito nakuha ko. after ng 'refresh' ok na ulet. not applicable to all batts pero no harm in trying kesa naman di na magamit!  

http://forum.allaboutcircuits.com/newsgroups/viewtopic.php?t=31965

The NP-FS11 (one of the first InfoLITHIUM batteries) is a well-known source
of trouble. Am using it in my DSC-F505 for years, never without problems.
Most people experience a different problem than you do: Fully charged
battery stops working in the camera after a few minutes, pretending it's
empty. In fact it's not (have discharged mine outside of the camera,
capacity is ok) but the InfoLITHIUM circuitry somehow sends out incorrect
battery status data to the camera.
Sometimes such problems can be cured by performing a full discharge-charge
cycle. Load the battery by a resistor (5...20 ohms) and drain it all the way
down. The protection circuitry will prevent a deep discharge. Then do a full
charge using the original charger. This may help to reset the calibration
data stored inside the battery.